Yamaha XMAX 300 Gear Oil Capacity (2017-2024)
1. Pre-ride Inspection
Before each ride, examine the final transmission case for any signs of oil leakage. If any leakage is detected, promptly consult a Yamaha dealer for inspection and repairs.
2. Final Transmission Oil Change Procedure
Change the final transmission oil at the intervals specified in the xmax 300 periodic maintenance and lubrication chart. Follow these steps:
-
Warm Up the Oil
Start the engine and warm up the final transmission oil by riding the scooter for several minutes, then turn off the engine. -
Stabilize the Scooter
Place the scooter securely on the centerstand to prepare for the oil change. -
Prepare for Draining
Position an oil pan under the final transmission case to collect the used oil. -
Remove the Oil Filler Cap
Take off the final transmission oil filler cap and its O-ring from the final transmission case.
-
Drain the Oil
Remove the final transmission oil drain bolt and its gasket to drain the oil into the pan.
-
Reinstall the Drain Bolt
Install the final transmission oil drain bolt along with a new gasket. Tighten the bolt to the specified torque.Tightening Torque
Final transmission oil drain bolt: 20 N·m (2.0 kgf·m, 15 lb·ft) -
Refill with Recommended Oil
Carefully refill the case with the specified amount and type of final transmission oil, ensuring no foreign material enters the case. Avoid spilling oil onto the tire or wheel.Recommended Oil Specifications
- Type: Motor oil SAE 10W-40, type SG or higher
- Oil Quantity: 0.20 L (0.21 US qt, 0.18 Imp.qt)
-
Replace the Filler Cap
Install the final transmission oil filler cap with a new O-ring and tighten it securely. -
Final Inspection for Leakage
Inspect the final transmission case for any signs of oil leakage. If leakage persists, investigate the cause and address it immediately.
